RC Elétrico - o fórum de automodelismo elétrico!

Não consegui ver pq não consegui registrar -.-
mas não faço a minima ideia de como fazer um desse...

as youve seen, i chosen this bit.


make sure that it fits first before hacking away at the lexan.


mark out a section at a time to cut out for a good fit.


ive cut out a section to bend the lexan to the shape of the light bucket.



now, get the other side of the the lexan piece. this is the easy part. all you have to do is copy what you have done so far by getting the 2 parts to match and mark the cut out with marker and cut excess off.




use the hot glue gun to join the bent section of the wall to finish off the shape.


i use phone line because they are lighter than you speaker wires.


drill the holes for the led's. i used these plastic chrome pieces from a light that i bought from the $2 dollar shop and i just dismantle and de solder the led's.


i used a parallel cicuit method if thats what its called to solder the led's. make sure that they are thesame distance as the holes that you drilled on the light bucket.



paint the lexan from the back like you would your shell. if you want to, you can add stickers all over it on the inside before you seal it off on the inside.



once you have finished the painting, glue the lights to the buckets and make sure that you glu the wires so it will stay intact if you get a hit or if you hit something.


when you install the buckets to the shell, make sure that you completely seal around the shape of the bucket because dust and dirt can get in there and is very hard to clean. why clean something that dont need cleaning right?
this is on my amg shell as an example.

Ninguém sabe me ajudar quanto à onde achar esses suportes de leds,
para eu prender na bolha, simulando tipo um faról de carro de verdade?

Valeu Fabio, resolveu tudo! Só mais uma coisa, o resistor eu ponho apenas no primeiro da serie?